Microstructure, Mechanical Properties and Fracture Behavior of As-Extruded Zn-Mg Binary Alloys

• 来源期刊: 金属学报（英文版）
• 年，卷（期）: 2017,（10）
• 页码范围: 931-940
• 页数: 10页
• 语种: 英文
• DOI: 10.1007/s40195-017-0585-4

摘要

In the present work,Zn-(0-1)Mg (wt％) alloys were prepared by casting and indirect extrusion at 200 and 300 ℃,respectively.With Mg addition,both the size and amount of second phase Mg2Zn11 increased,and the equiaxed grains were significantly refined.The extrusion temperature had little influence on Mg2Zn1 1,but the grains were refined at low extrusion temperature.For the alloys extruded at 200 ℃,as Mg content increased,the tensile yield strength (TYS) increased from 64 MPa for pure Zn to 262 MPa for Zn-1Mg;the elongation increased from 14.3％ for pure Zn to 25％ for Zn-0.02Mg and then decreased to 5％ for Zn-1Mg.For the alloys extruded at 300 ℃,as Mg content increased,the TYS increased from 67 MPa for pure Zn to 252 MPa for Zn-1Mg,while the elongation decreased from 1 1.7％ to 2％.The alloy extruded at 200 ℃ exhibited higher TYS and elongation than the corresponding alloy extruded at 300 ℃.The combination of grain refinement and second phase Mg2Zn11 contributed to the improvement in the TYS,and the grain refinement played a major role in strengthening alloy.Zn-0.02Mg and Zn-0.05Mg alloys extruded at 200 ℃ show a mixture of cleavage and ductile fracture corresponding to higher elongation,while the other alloys show cleavage fracture.