Investigation of Work Hardening Behavior of Inconel X-750 Alloy

• 来源期刊: 金属学报（英文版）
• 年，卷（期）: 2017,（9）
• 页码范围: 869-877
• 页数: 9页
• 语种: 英文
• DOI: 10.1007/s40195-017-0607-2

摘要

The constant strain rate uniaxial compression tests were conducted in this paper for studying the work hardening behavior and revealing the underlying microstructure evolution involved in the plastic response of the nickel-based Inconel X-750 alloy.The work hardening rate versus true strain plots of Inconel X-750 alloy resembled that of low-stacking-fault energy (SFE) alloys with distinct four stages.The dislocations were found in the planar arrangements at a strain of 0.1 located at the onset of stage Ⅱ,and the dislocation density was increased and the planar arrangement configuration was partially destroyed at a strain of 0.36 located in stage Ⅲ.It was unexpected that deformation twins were observed at a strain of 0.69 located in stage Ⅳ although the alloy has been classified into materials with a higher SFE value.The result is different with a similar study,in which the deformation twins were absent in Ni-Cr-based alloy Inconel 625 even when the strain was as high as 0.65.It was deemed that the low level of solution strengthening favored the deformation of matrix and the activation of slip system for twining in Inconel X-750 alloy.Unlike the low-SFE alloys that the twins were always formed at the end of stage Ⅰ,the higher SFE delayed the twin formation to stage Ⅳ for Inconel X-750 alloy.The welldeveloped planar dislocation configuration gave rise to the stage Ⅱ with a slightly decreasing rate,the collapse of planar dislocation arrangements caused the occurrence of stage Ⅲ with an accelerated decreasing rate,and the twin formation led to the stage Ⅳ with a nearly constant work hardening rate.