Determination of the Calcination Procedure Required to Activate Edda Clay for Optimal Leaching of Alumina

• 作者: Charles Nwachukwu Anyakwo Chijioke Samson Nwobodo Okechukwu Onyebuchi Onyemaobi Udochukwu Mark
• 来源期刊: 矿物质和材料特性和工程(英文)
• 学科: 医学
• 关键词: Edda CLAY Bauxite KAOLINITE ALUMINA CALCINATION Thermal Activation LEACHING
• 年，卷（期）: 2019,（2）
• 页码范围: 49-63
• 页数: 15页
• 分类号: R73

摘要

Nigeria is the highest consumer of aluminium in Africa but lacks bauxite deposits. The replacement of bauxite alumina with other alumina bearing resources (clays in particular) has been proposed. The present study investigated the thermal treatment required to activate Edda clay from southeastern Nigeria for optimal leaching of alumina. The clay is composed mainly of kaolinite and quartz, assaying 24.65% Al2O3 and 52.81% SiO2. Thermal activation of the clay prior to leaching transformed the crystalline kaolinite mineral to an amorphous phase (metakaolinite) in which the alumina became soluble. Clay samples passing 300 μm sieve were calcined at temperatures of 500°C, 600°C, 700°C, 800°C, and 900°C at holding times of 30, 60, and 90 minutes in each case. The uncalcined clay and sample heated at 1000°C (for 60 minutes) were used in the control experiments. Leaching of alumina from the resulting clay calcines was done in 1 M hydrochloric acid solution at room temperature using a solid/liquid ratio of 0.02 g/ml and shaking speed of 100 rpm. The solubility data based on the percentage of Al ions taken into leach solution showed that the sample calcined at 700°C (for 60 minutes) responded to leaching better than other samples. Samples calcined for 60 minutes at all temperatures studied were found to respond more than those held for 30 or 90 minutes. Studies on the activation energy of leaching revealed that calcines produced at 700°C (for 60 minutes) had both the highest leaching response (49.96% after 1 hour at leaching temperature of 100°C) and the lowest activation energy of 24.47 kJ/mol. It is concluded therefore that Edda kaolinite clay should be thermally activated for alumina yield by heating up to 700°C and holding for 60 minutes. The clay deposit is therefore a potential alternative resource for alumina production.