A Qualitative Study of the Influence of Grooved Mold Surface Topography on the Formation of Surface Marks on As-Cast Ingots of Aluminum Alloy 3003

• 作者: Prince N. Anyalebechi
• 来源期刊: 材料科学与应用期刊(英文)
• 学科: 工学
• 关键词: RIPPLES LAPS Grooved Mold SURFACE TOPOGRAPHY Casting Aluminum Alloy Lap Formation
• 年，卷（期）: clkxyyyqkyw_2020,（4）
• 页码范围: 263-284
• 页数: 22页
• 分类号: TG1

摘要

The effects of the wavelength and orientation of machined grooves on a mold surface, casting speed, and melt superheat on the formation of surface marks on as-cast ingots were studied with an immersion casting tester and copper mold chill blocks. The mold surface topographies included a polished smooth surface, and those with machined unidirectional parallel contoured grooves oriented either parallel (vertical) or perpendicular (horizontal) to the casting direction. The unidirectional grooves were 0.232 mm deep with wavelength or spacing between 1 and 15 mm. The casting speed and melt superheat were between 1 and 200 mm/s, and 10 and 50 K, respectively. Two primary types of surface marks were observed on ingots cast with the copper mold with smooth surface topography, namely the finer and closely spaced ripples (Type I), and the widely spaced but coarser laps (Type II). The latter were more prevalent at the higher casting speeds and melt superheats. Qualitatively, formation of both types of surface marks on the as-cast ingots of the aluminum alloy 3003 appeared to be alleviated by increase in casting speed and melt superheat, and by the use of molds with grooved surface topography. In fact, casting with a mold surface with 1 mm spaced grooves that are perpendicular to the casting direction eliminated the formation of surface marks at casting speeds greater than 1 mm/s. It also improved the uniformity of the ingot subsurface microstructure and eliminated the associated subsurface segregation.