Multi-fluid Eulerian simulation of binary particles mixing and gas-solids contacting in high solids-flux downer reactor equipped with a lateral particle feeding nozzle

• 作者: Qiang Zheng Jingxuan Yang Wenhao Lian Baoping Zhang Xueer Pan Zhonglin Zhang Xiaogang Hao Guoqing Guan
• 来源期刊: 中国化学工程学报（英文版）
• 年，卷（期）: 2021,（7）
• 所属期刊栏目: Fluid Dynamics and Transport Phenomena
• 页码范围: 152-162
• 页数: 11页
• 语种: 英文

摘要

The performance of binary particles mixing and gas-solids contacting,which is considered qualitatively to have a significant influence on the heat transfer in internal heated circulating fluidized beds,is care-fully investigated by means of a numerical approach in the newly developed high solids-flux downer lig-nite pyrolyzer (φ0.1 m × 6.5 m).Since binary particles are used in this system,a reasonably validated 3D,transient,multi-fluid model,in which three heat transfer modes relating to the convection,conduction and radiation are considered,is adopted to simulate the flow behavior,temperature profiles as well as volatile contents.The simulation results showed that the solids stream impinges the left wall surface ini-tially and turns towards the right wall in the further downward direction and then shrinks during this process resulting in that the solids concentrate a little more at the central region.In the further down-ward section of the downer,the particle flow disperses near the right wall and develops uniformly.Meanwhile,the coal phase is slowly heated in the downer and it is found that most of the heat absorbed by the coal is from the convection heat transfer mode.To explore the heat transfer mechanism more quantitatively,two indexes (mixing index and contacting index) are proposed,and it is found that the mixing index initially increased fast and later remained at a relatively flat state.For the contact index,it shows a trend with a first rising and then falling,finally rising continuously.Also,it is found that the convection heat transfer is closely correlated to the contacting status of gas-coal which indicates that the improving of the gas-coal contacting efficiency should be an effective way to strengthen the coal par-ticle heating process.