Effects of Collectors and Frothers on Copper and Molybdenum Coarse Particle Recoveries—A Statistical Approach

• 作者: Rolando Lastra Tony Di Feo
• 来源期刊: 矿物质和材料特性和工程(英文)
• 学科: 医学
• 关键词: MINERAL PARTICLES PHYSICAL PARAMETERS Coarse PARTICLES FLOTATION
• 年，卷（期）: 2019,（3）
• 页码范围: 117-136
• 页数: 20页
• 分类号: R73

摘要

Typically, coarse dense mineral particles greater than 150 μm are difficult to float, and the recovery decreases progressively. Various physical parameters can be manipulated in an attempt to increase the recovery. These physical parameters are the following: liberation, turbulence in the flotation cell, pH, collector, frother type and dosage. The testwork discussed in this paper was performed for a copper-molybdenum operation that is experiencing coarse particle (>150 μm) losses in the tails. This operation uses Diesel No. 2 fuel and sodium ethyl xanthate for molybdenum and copper flotation, respectively and X-133 frother. In an attempt to increase coarse particle recovery, stronger collectors (potassium amyl xanthate, Aero 249 and Aero 3501) and frothers (FrothPro 618, FrothPro 630 and FrothPro 706) were used. The analysis was performed using the Analysis of Variance (ANOVA) approach. The conditions required by the ANOVA method were met. The results showed that the collector potassium amyl xanthate (PAX) with frothers X-133 and FrothPro 630 resulted in approximately 3% increase in copper rougher recovery relative to the baseline (sodium ethyl xanthate and X-133). The collectors and frothers did not have a significant effect on molybdenum recovery within the dosage limits investigated.