Gate Optimization Analysis of Injection Molding for Mobile Phone Panel Based on Moldflow and Drop Simulation

• 作者: Hongbing Wang Chunhua Sun
• 来源期刊: 世界工程和技术(英文)
• 学科: 工学
• 关键词: Drop Simulation GATE Weld Lines
• 年，卷（期）: 2021,（1）
• 页码范围: 92-99
• 页数: 8页
• 分类号: TN9

摘要

Aiming at the gate design problem of a mobile phone panel, the plastic forming analysis software Moldflow and drop simulation were used to optimize the gate design. Six different gate design schemes were compared and studied, and the weld lines positions and injection molding results under each gate scheme were analyzed.</span><span style="font-family:""></span><span style="font-family:Verdana;">Through the simulation analysis of the falling process of the mobile phone panel by the display dynamics analysis software ANSYS Workbench LS-DYNA, five analysis schemes were set according to the falling angle, and the stress distribution at the weld lines positions of the mobile phone panel in each scheme was studied. The reasonable gate scheme was given by synthesizing the force condition, the mold flow analysis and the drop simulation results of the mobile phone panel in use. Based on the results of die flow analysis and drop simulation the optimal gate design scheme 2 is found, and the weld line position avoids the lower part of the elliptical hole, which is the weak part of the structure. The research results had certain reference significance for the optimization of injection process of plastic products.