Experimental Behavior of Partially Prestressed High Strength Concrete Beams

• 作者: Ahmed S. Essawy Khalid M. Hilal Shady H. Salem Tarek K. Hassan
• 来源期刊: 土木工程期刊(英文)
• 学科: 工学
• 关键词: PARTIALLY PRESTRESSED High Strength Concrete BEAMS SERVICEABILITY BEHAVIOR Failure Modes
• 年，卷（期）: 2013,（3）
• 页码范围: 26-32
• 页数: 7页
• 分类号: TU3

摘要

In the last few decades, prestressed concrete has been rapidly used in bridge engineering due to the enormous development in the construction techniques and the increasing need for long span bridges. High strength concrete has been also more widely spread than the past. It currently becomes more desirable as it has better mechanical properties and durability performance. Major defect of fully prestressed concrete is its low ductility;it may produce less alarming signs than ordinary reinforced concrete via smaller deflection and limited cracking. Therefore, partially prestressing is considered an intermediate design between the two extremes. So, combining high strength concrete with partial prestressing will result in a considerable development in the use of prestressed concrete structures regarding the economical and durability view points. This study presents the results of seven partially prestressed high strength concrete beams in flexure. The tested beams are used to investigate the influence of concrete compressive strength, prestressing steel ratio and flange width on the behavior of partially prestressed beams. The experimentally observed behaviors of all beams were presented in terms of the cracking load, ultimate load, deflection, cracking behavior and failure modes.