Effects of Sand Quality on Compressive Strength of Concrete: A Case of Nairobi County and Its Environs, Kenya

• 作者: Hannah Nyambara Ngugi Raphael Ndisya Mutuku Zachary Abiero Gariy
• 来源期刊: 土木工程期刊(英文)
• 学科: 医学
• 关键词: SAND QUALITY Silt and Clay IMPURITIES Organic IMPURITIES CONCRETE Cube Compressive Strength BUILDINGS Collapse BUILDINGS Failure
• 年，卷（期）: 2014,（3）
• 页码范围: 255-273
• 页数: 19页
• 分类号: R73

摘要

Failure of concrete structures leading to collapse of buildings has initiated various researches on the quality of construction materials. Collapse of buildings resulting to injuries, loss of lives and investments has been largely attributed to use of poor quality concrete ingredients. Information on the effect of silt and clay content and organic impurities present in building sand being supplied in Nairobi County and its environs as well as their effect to the compressive strength of concrete was lacking. The objective of this research was to establish level of silt, clay and organic impurities present in building sand and its effect on compressive strength of concrete. This paper presents the findings on the quality of building sand as sourced from eight supply points in Nairobi County and its environs and the effects of these sand impurities to the compressive strength of concrete. 27 sand samples were tested for silt and clay contents and organic impurities in accordance with BS 882 and ASTM C40 respectively after which 13 sand samples with varying level of impurities were selected for casting of concrete cubes. 150 mm × 150 mm × 150 mm concrete cubes were cast using concrete mix of 1:1.5:3:0.57 (cement:sand:coarse aggregates:water) and were tested for compressive strength at the age of 7, 14 and 28 days. The investigation used cement, coarse aggregates (crushed stones) and water of similar characteristics while sand used had varying levels of impurities and particle shapes and texture. The results of the investigations showed that 86.2% of the sand samples tested exceeded the allowable limit of silt and clay content while 77% exceeded the organic content limit. The level of silt and clay content ranged from 42% to 3.3% for while organic impurities ranged from 0.029 to 0.738 photometric ohms for the unwashed sand samples. With regard to compressive strength, 38% of the concrete cubes made from sand with varying sand impurities failed to meet the design strength of 25 Mpa at the age of 28 days. A combined r