An investigation on machined surface quality and tool wear during creep feed grinding of powder metallurgy nickel-based superalloy FGH96 with alumina abrasive wheels

• 作者: Ben-Kai Li Min Li Qing Miao Wen-Feng Ding Xi Zhang
• 来源期刊: 先进制造进展（英文版）
• 关键词: Creep feed grinding Powder metallurgy nickel-based superalloy Surface quality Alumina abrasive wheel Tool wear
• 年，卷（期）: 2020,（2）
• 页码范围: 160-176
• 页数: 17页
• 语种: 英文

摘要

In this study,the machined surface quality of powder metallurgy nickel-based superalloy FGH96 (similar to Rene88DT) and the grinding characteristics of brown alumina (BA) and microcrystalline alumina (MA) abrasive wheels were comparatively analyzed during creep feed grinding.The influences of the grinding parameters (abrasive wheel speed,workpiece infeed speed,and depth of cut) on the grinding force,grinding temperature,surface roughness,surface morphology,tool wear,and grinding ratio were analyzed comprehensively.The experimental results showed that there was no significant difference in terms of the machined surface quality and grinding characteristics of FGH96 during grinding with the two types of abrasive wheels.This was mainly because the grinding advantages of the MA wheel were weakened for the difficult-to-cut FGH96 material.Moreover,both the BA and MA abrasive wheels exhibited severe tool wear in the form of wheel clogging and workpiece material adhesion.Finally,an analytical model for prediction of the grinding ratio was established by combining the tool wear volume,grinding force,and grinding length.The acceptable errors between the predicted and experimental grinding ratios (ranging from 0.6 to 1.8) were 7.56％ and 6.31％ for the BA and MA abrasive wheels,respectively.This model can be used to evaluate quantitatively the grinding performance of an alumina abrasive wheel,and is therefore helpful for optimizing the grinding parameters in the creep feed grinding process.